ENGLISH
E
After Each Use
• Ensure the clipper is switched off and disconnected from the mains.
• Brush the accumulated hair from the blades. Do not submerge the clipper in water.
• To clean unit, wipe with damp cloth and dry immediately.
C WASHABLE CLEANING
The QUICK WASH SYSTEM is designed to maximise the efficiency of washable cleaning.
• Click the buttons that are located on the sides of the hair clipper head. The blades will
slide out and the blade set can be easily cleaned under the tap.
• Once the blades are cleaned the blades are locked into place by pushing the blade set
towards the hair clipper head and will snap into place.
• Do not run the entire unit under the tap, only the blade set is meant to be submerged in
water.
Note: Ensure the clipper is turned off when cleaning.
, EVERY SIX MONTHS
• At regular intervals the blade set should be removed and cleaned.
• Remove the 2 screws retaining the fixed blade with a screwdriver. Do not remove blade
set.
• Brush out hairs from between the blades with soft cleaning brush. Do not remove the
lubricating grease from the blades. It is not necessary to remove the small moving blade
from the unit.
• If the moving blade has been removed this can be re-fitted by slotting the coated blade
holder over the pin in the centre of the interior product head. The groove on the coated
blade, just below the teeth, rests on a metal plate at the opposite side to the screw holes.
The fixed blade is fitted with the raised profile pointing outwards and fixed with the 2
screws.
, Note that if the blades are not correctly aligned then cutting efficiency will be impaired.
• Place a few drops of cutter or sewing machine oil onto the blades. Wipe off excess oil.
A CLEANING CAUTIONS
• Only the attachment guide combs and trimmer blade may be removed from the product
for cleaning.
• Cleaning should be done with a soft brush, such as the brush supplied with the product.
• Do not use harsh or corrosive cleaners on the units or their blades.
7