Hilti SFC 22-A Mode D'emploi page 7

All manuals and user guides at all-guides.com
The working environment may be as follows: construction site,
workshop, renovation, conversion or new construction.
2.2 Chuck
Keyless chuck
2.3 Switches
Control switch with electronic speed control
2-speed gear selector switch
Forward / reverse selector switch with safety lock
Torque and drilling mode setting ring
2.4 Grips
Vibration-absorbing grip
2.5 Lubrication
Grease lubrication
2.6 The items supplied include (toolbox versions):
1 Power tool
1 Operating instructions
1 Hilti toolbox
2.7 The items supplied include (cardboard box versions):
1 Power tool
1 Operating instructions
2.8 Additional items required for operating the tool
B 22/1.6 Li­Ion, B 22/2.6 Li­Ion, B 22⁄3.3 Li­Ion, B 14/1.6 Li­Ion
or B 14/3.3 Li­Ion battery with C4⁄36­90, C4⁄36­350, C 4/36,
C 4/36­ACS or C 4/36­ACS TPS charger.
2.9 Li-ion battery charge status and overheating indicator
LEDs light con-
LEDs blink
stantly
LED 1, 2, 3, 4 -
LED 1, 2, 3 -
LED 1, 2 -
LED 1 -
- LED 1
- LED 1
2.10 Overload and overheating protection
The power tool is equipped with an electronic protection system
to prevent overloading and overheating. The power tool switches
itself off automatically in the event of overloading and overheating.
After releasing the control switch, the power tool may not restart
immediately when the switch is pressed again (while the power
tool is cooling down).
3 Insert tools, accessories
Designation Short designation
Bit holder S-BH 50
Charger for Li-ion batteries C 4/36
Charger for Li-ion batteries C 4/36­ACS
Charger for Li-ion batteries C 4/36-ACS TPS
Charger for Li-ion batteries C 4/36­90
Charger for Li-ion batteries C 4/36­350
Battery B 22/1.6 Li­Ion
Battery B 22/2.6 Li­Ion
Battery B 22/3.3 Li­Ion
Battery B 14/1.6 Li­Ion
Printed: 30.09.2013 | Doc-Nr: PUB / 5152675 / 000 / 01
en
Charge status C
C ≧ 75 %
50 % ≦ C < 75 %
25 % ≦ C < 50 %
10 % ≦ C < 25 %
C < 10 %
Battery overheated
3