Ryobi RBL30MVB Manuel D'utilisation page 16

EN
FR DE ES IT PT
IF THESE SOLUTIONS DO NOT SOLVE THE PROBLEM CONTACT YOUR AUTHORISED SERVICE DEALER.
PROBLEM
Engine will not start.
Engine starts but will not
ac cel er ate.
Engine starts but will only run at
high speed at half choke.
Engine does not reach full speed
and emits excessive smoke.
Engine starts, runs, and
accelerates but will not idle.
960725012-01.indd 13 960725012-01.indd 13
NL SV DA NO FI HU CS RU
English (original instructions)
POSSIBLE CAUSE
No spark.
No fuel.
Engine is fl ooded.
Starter rope now harder to
pull than when new.
Carburetor requires adjust-
ment.
Carburetor requires adjust-
ment.
Check lubricant fuel mixture.
Air fi lter is dirty.
Spark arrestor screen is dirty.
Idle speed screw on carbure-
tor requires adjustment.
13 13
RO PL SL HR ET LT
SOLUTION
The spark plug may be damaged, remove it
and check for dirt and cracks. Replace with a
new spark plug.
Push primer bulb until bulb is full of fuel. If bulb
does not fi ll, primary fuel delivery sys tem is
blocked. Con tact a servicing dealer. If prim er
bulb fi lls, engine may be fl ooded, proceed to
next item.
Remove spark plug, turn blower so spark plug
hole is aimed at the ground. Adjust the choke
lever to " " position and pull starter cord
10-15 times. This will clear excess fuel from
en gine. Remove any fuel which splashed on
the product. Clean and reinstall spark plug.
Clean up any spilled fuel and move at least 9m
away before restarting. Pull starter 3 times with
choke lever at " ". If en gine does not start,
rotate choke lever to " " position and repeat
normal starting pro ce dure. If engine still fails to
start, repeat pro ce dure with a new spark plug.
Contact a servicing dealer.
Contact a servicing dealer.
Contact a servicing dealer.
Use fresh fuel and the correct 2-stroke
lubricant mix.
Clean air fi lter. Refer to Cleaning the Air Filter
Screen earlier in this manual.
Contact a servicing dealer.
Turn idle speed screw clockwise to increase
idle speed.
LV SK BG
14/02/2011 10:35 AM 14/02/2011 10:35 AM