Greenlee KRW-1 Manuel D'utilisation page 4

IMPORTANT SAFETY INFORMATION
A component failure could throw
broken parts.
• Do not allow anyone to stand in
front of the punch.
Failure to observe this warning
could result in severe injury or death.
Do not attempt to punch a hole
through two or more layers of mate-
rial. This will bend or break the draw
stud, and could throw parts with
great force.
Failure to observe this warning
could result in severe injury or death.
Set up the tool properly. An improper setup could
cause a component to fail and strike nearby person-
nel with great force.
• Use only Greenlee punches, dies, and drawstuds.
Other manufacturers' components might not with-
stand the forces generated by this punch driver.
• Manual Punch Setup: The punch must be
threaded completely onto the drawstud. All of the
punch threads must be engaged by the drawstud
threads. Incomplete assembly could cause a com-
ponent failure.
• Hydraulic Punch Setup: The drawstud must be
threaded completely into the driver head. The
punch must be threaded completely onto the
drawstud. All of the punch threads must be
engaged by the drawstud threads. Incomplete
assembly could cause a component failure.
• SPEED PUNCH Setup: The drawstud must be
threaded completely into the driver head. The
SPEED LOCK must fully engage and completely
close on the drawstud. Incomplete assembly
could cause a component failure.
Failure to observe these warnings could result in
severe injury or death.
Greenlee Tools, Inc.
Punches for Manual Tool Use
• Inspect tool for wear or damage. A damaged or
improperly assembled tool can break and strike
nearby personnel with sufficient force to cause
severe injury or death.
• Inspect the punch, die, draw stud, and spacers for
wear or damage. Replace any worn or damaged
items. Replace any punches that have dull cutting
surfaces.
Do not exceed the rated capacity of this tool.
Exceeding the rated capacity could cause a com-
ponent failure, which could throw broken parts with
great force.
Failure to observe this warning could result in severe
injury or death.
Ensure the punch cycle is stopped after a hole is
made. Failure to do so could cause a part collision
which could throw broken parts.
Failure to observe this warning could result in severe
injury or death.
Use this tool for the manufacturer's intended
purpose only. Use other than that which is
described in this manual can result in injury or
property damage.
Note: Keep all decals clean and legible, and replace
when necessary.
4
4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070