Publicité
Les langues disponibles
Les langues disponibles
Stop operation and remove unit from
window in severe storm or hurricane.
• Operation during a severe storm may
allow a significant amount of water to
enter the indoors.
Do not place obstacles around air-intake
vents or inside cool air outlet.
• It may cause failure of appliance.
Do not use strong detergent such as
wax or paint thinner to clean the unit.
Use a damp, soft cloth.
• Appearance may deteriorate due to
change of product color or scratching of
its surface.
ELECTRICAL INFORMATION
CAUTION
• Be sure your electrical wiring is adequate for the model you have chosen. This information can be found on
the rating label, a silver-colored sticker generally located on the right side of the cabinet.
• Be sure the air conditioner is properly grounded. To minimize shock and fire hazards, proper grounding is
important. The power cord is equipped with a three-prong
grounding plug for protection against shock hazards.
• Your air conditioner must be connected to a properly
grounded wall receptacle. If the wall receptacle you intend to
use is not adequately grounded or protected by a time delay
fuse or circuit breaker, have a qualified electrician install the proper
receptacle.
• Ensure the receptacle is accessible after the unit installation.
The power supply cord contains a current device that senses damage to
the power cord and excess current draw from the unit. To test your cur-
rent device do the following:
1.
Plug in the Air Conditioner.
2.
Press the TEST button. You will hear a click as the RESET button
pops out within the rubber housing and the LED will turn off.
3.
Press the RESET button. You will hear a click as the button
engages and the LED will illuminate.
4.
The power supply cord is now supplying electricity to the unit.
Note: Your model may have the TEST and RESET buttons on the
side or the front of the plug head.
NOTES:
• Do not use the TEST and RESET buttons to turn the unit on or off.
• If the current device fails the test or the power cord becomes dam-
aged, the entire power cord must be replaced with an equivalent
power cord and current device by a licensed electrician.
All manuals and user guides at all-guides.com
CAUTION
Hold the plug by the head of the power
plug when unplugging unit.
• Pulling from the wire can cause wire to
fray leading to electric shock or fire.
If unit is equipped with an outdoor instal -
lation bracket, periodically ensure that it
has not become damaged.
• If bracket is damaged, the unit can fall
and cause damage, personal injury or
death.
Do not place heavy objects on the
power cord and ensure that the cord
is not pinched or stressed.
• There is danger of fire or electric shock.
–5–
Unplug the power cord when not
using the unit for extended periods
of time.
• Will prevent damage to the unit.
Always insert the filters securely.
Clean filter at least once per month.
• Operation with dirty filters (or without
filters) will effect performance and
may cause damage to the unit.
Do not place this window-type air
conditioner through a wall.
• This will block the side vents and pre -
vent the unit from cooling properly.
NOTE:
The power supply cord with this air conditioner
contains a current detection device designed to reduce the
risk of fire. In the event that the power supply cord is dam-
aged, it cannot be repaired -- it must be replaced with a cord
from the Product Manufacturer.
Do not, under any
circumstances, cut,
remove, or bypass
the grounding prong.
Power supply cord with 3-prong
grounding plug and current detection
device
Side button
version
Publicité
Chapitres
Dépannage
