Camera Adjustment - Eneo VKCD-1326/IR Mode D'emploi

All manuals and user guides at all-guides.com

6. Camera Adjustment

a Service Monitor
Connector
b DC Level
Adjustment V.R
c Function Selection
Switch
CAUTION: In case of AGC off, the switching of D&N doesn't work.
Because the D&N switching function is related in AGC level.
Setup of the Image Sector
• Pull off the camera housing.
• Power up the camera and connect a monitor.
• Open the zoom handle (7) (see page 9). Turn the ring to adjust the zoom setting.
• Focus is adjusted by turning the focus handle (6).
• Tighten both handles (6) + (7) when adjustment is done. Close the housing.
Use service monitor connector to set camera angle &
focus when installing.
• BLC (Backlight Compensation)
• AGC (Automatic Gain Control)
• D/N (Day & Night) ON/OFF
• DSS (Digital Slo Shutter) ON/OFF
• D/Z (Digital Zoom) ON/OFF
• FL (Flickerless) ON/OFF
0