UPPAbaby VISTA Mode D'emploi page 8

CARRYCOT OPERATION
ATTACHING CARRYCOT TO PUSHCHAIR FRAME
To Attach Carrycot to Pushchair Frame: Guide the
carrycot hubs over the posts on the pushchair frame.
Push until you hear a "click" on both sides.
NOTE: Check that safety indicator is green to ensure
carrycot is properly installed.
CANOPY VENTILATION
STEP 1: Unzip the bottom zipper STEP 2: Lift and line up seam
on the canopy hood. half-way until magnets connect.
COLLAPSING CARRYCOT
STEP 1: Collapse carrycot canopy by simultaneously
pressing buttons on both sides and pushing back.
13
To Remove Carrycot from Pushchair Frame: Slide
plastic button on carry handle in the direction indicated
and press down to release carrycot. Lift carrycot off
frame using carry handle.
For Additional Ventilation: Undo
Velcro flap found on bottom
exterior of carrycot and adhere to
lower Velcro strip.
STEP 2: Lift mattress out of the way. Disengage by
pulling steel braces from their respective sockets.
CARRYCOT OPERATION
PROPER USE OF ACCESSORIES
Using Carrycot Storage Bag: Slide collapsed carrycot
into bag and fasten Velcro tab.
REMOVING CARRYCOT FABRICS
STEP 1: Unzip canopy zippers located STEP 2: Pull canopy support frame
on the underside of canopy where from hub on one side.
fabric meets the carry handle.
STEP 4: Slide fabric off canopy support frame.
Proper Use of Carrycot Insect Net
STEP 3: Detach support frame from
rear clip.
To Remove Carrycot Fabric: Unzip liner from
interior carrycot frame.
14