Milwaukee 2445-20 Manuel De L'utilisateur page 4

ASSEMBLY
Recharge only with the charger
WARNING
specified for the battery. For spe-
cific charging instructions, read the operator's
manual supplied with your charger and battery.
Removing/Inserting the Battery
To remove the battery, push in the release buttons
and pull the battery pack away from the tool.
Always remove battery pack before
WARNING
changing or removing accessories.
To insert the battery, slide the pack into the body
of the tool. Make sure it latches securely into place.
Only use accessories specifically
WARNING
recommended for this tool. Others
may be hazardous.
Installing saw blades
Use only T-Shank jig saw blades.
1. Remove the battery pack.
2. Pull out and hold the Quik-Lok tension lever.
3. Fit the saw blade into the groove in the support roller
and push it firmly into the plunger as far as it will
go; the lug of the saw blade must be in the plunger.
4. Release the Quik-Lok tension lever to secure the
saw blade.
5. Check that the saw blade is held firmly; the slot in
the plunger will be at an angle to the blade.
Plunger
Support
Lug
roller
Using the anti-splinter device
The anti-splinter device helps sta-
bilize the workpiece and reduce
workpiece splinter.
1. Remove the battery pack.
2. Slide the anti-splinter device
onto the shoe. Make sure
the anti-splinter device is in-
stalled flush with the bottom
of the shoe.
NOTE: Do not use the anti-
splinter device when making bevel/angle cuts.
Using the shoe cover
The shoe cover is used to prevent marring and scratch-
ing of the workpiece surface. To attach the shoe cover:
1. Remove the battery pack.
2. Hook the front of the cover over the metal shoe.
3. Snap the rear of the shoe cover over the back of
the shoe. Be sure both sides are snapped in place.
4. When the shoe cover is not needed, remove it by
pulling the tabs on rear of the shoe cover down.
Unhook the front of the shoe cover and remove.
All manuals and user guides at all-guides.com
Slot
Blade
Anti-splinter
device
Shoe
4
Adjusting the shoe
The shoe may be tilted up to 45° in either direction.
Do not use the anti-splinter device when making bev-
el/angle cuts. To set a tilt angle for bevel/angle cuts:
1. Remove the battery pack.
2. Loosen the shoe adjustment lever and pull the
base forward slightly.
3. To set the angle to 0°, push the shoe backward
into the 0° detent and tighten the shoe adjustment
lever.
4. To set any other angle, tilt the tool to the desired
angle and tighten the shoe adjustment lever. Make
a test cut to verify the angle.
OPERATION
To reduce the risk of injury, always
WARNING
wear proper eye protection marked
to comply with ANSI Z87.1.
When working in dusty situations, wear appro-
priate respiratory protection or use an OSHA
compliant dust extraction solution.
Always remove battery pack before changing
or removing accessories. Only use accessories
specifically recommended for this tool. Others
may be hazardous.
Starting and stopping the tool
1. To start the tool, grasp the handle firmly and pull
the trigger. An LED is turned on when the trigger
is pulled.
2. To vary the speed, increase or decrease pressure
on the trigger. The further the trigger is pulled, the
greater the speed.
3. To stop the tool, release the trigger. Allow the tool
to come to a complete stop before removing the
blade from a partial cut or laying the tool down.
Fuel Gauge
To determine the amount of charge left in the bat-
tery, pull the trigger. The Fuel Gauge will light up for
2-3 seconds.
To signal the end of charge, 1 light on the fuel gauge
will flash for 2-3 seconds.