Greenlee FG01 G-Serie Manuel D'instructions page 9

• Run calibration diagnose when this message is
shown. This is to ensure calibration is within range.
• Under the SETTINGS window click DIAGNOSE, to
access to the Diagnose test,
• Follow the instruction and press DIAGNOSE button to
get an status of the current force accuracy
Greenlee Tools, Inc.
FG01 G-Series Smart Pull
• If the Smart Pull pass the test, you will get a
message just like the one above
• If the Smart Pull fails the test, you will get a
message just like the one above. The recalibration
message can come out while pulling as well if an
error is detected with the calibration.
NOTE: Try to disconnect and connect back the load
cell censor. If this does not work. please contact
customer service, they will take care of you
9
4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070