Lexmark X820e MFP Mode D'emploi page 19

Power
supply (b)
Power
switch
Scanner
cable
Printer
Ethernet
cable (e)
Network
Ethernet
cable
Telephone fax
line cable (d)
Do not plug the power supply line cord
into an outlet until later (see "Turning on
the control unit and printer" on page 15).
Power supply
line cord (j)
1
Make sure the printer and control ke sure the printer and control
unit are turned off and unplugged.
2
Attach the end of the scanner
cable with the toroid to the
scanner and the other end to the
control unit. Tighten the
thumbscrews on both ends of the
cable.
3
Connect the end of the Ethernet
cable (e) with the toroid to the
Ethernet port 1 on the control unit
and the other end to the printer.
4
Connect the adapter to the
telephone fax line cable if
necessary. Connect the telephone y. Connect the telephone
fax line cable (d) to the control unit
and then to a phone jack.
5
Connect standard cabling
compatible with your network to
the Ethernet port 2 on the control
unit, and then to a network
connection. This cable is not This cable is not
provided by Lexmark.
6
Connect the power supply (b) to
the control unit.
Attach cables and cords
11