Before Using For The First Time - Russell Hobbs 21702-56 Mode D'emploi

BEFORE USING FOR THE FIRST TIME

Fill the reservoir to the max mark, and run the appliance without coffee.
FILLING
1. Remove the carafe from the hotplate.
2. Use the grip to open the lid, and expose the reservoir.
3. Fill with at least 2 cups of water, but not above the max mark.
4. Open up a #4 paper filter, and put it into the filter holder.
5. Put 1 scoop of filter-ground coffee into the filter for each cup.
6. Close the lid.
7. Replace the carafe on the hotplate.
SWITCH ON
CAUTION: DO NOT open the lid during brewing as there is the potential risk of scalding.
1. Put the plug into the power socket.
Move the switch to I. The light will come on.
2.
3. Shortly afterwards, coffee will start to drip into the carafe.
4. When it's done, the hotplate will keep the carafe warm. After 40 minutes, the hotplate and appliance
will shut down.
5. Move the switch to O.
6. Unplug, and let the appliance and carafe cool down fully before cleaning, or for about 10 minutes
before refilling.
7. For the best flavour, drink the coffee within 40 minutes of brewing.
BREWING STATUS GAUGE
The gauge shows the status of your coffee machine.
• The pointer will first show the brewing stage as your coffee is being made. The pointer will move
slowly clockwise within the first (long) segment during brewing.
Once brewing has finished, the pointer will move to the 0 marking. It will then show, in minutes, how
•
long the coffee has been kept warm by the hot plate (0 to 40 mins). After about 40 minutes,
chemical changes will affect the taste of the coffee.
• When the appliance shuts down, the pointer will move to the rest position.
4