Maytag MGDE200XW Instructions Pour L'installation page 6

Back view:
Electric
Back exhaust
vent location
NOTE: Most installations require a minimum of 5" (127 mm)
clearance behind dryer for exhaust vent with elbow. See "Venting
Requirements."
IMPORTANT: Do not operate, install, or store dryer where
it will be exposed to water, weather, or at temperatures below
45° F (7° C). Lower temperatures may cause dryer not to
shut off at end of automatic sensor cycles, resulting in longer
drying times.
Installation spacing for recessed area or closet
installation
All dimensions show recommended spacing allowed, with tested
spacing of 0" (0 mm) clearance on sides and rear.
Additional spacing should be considered for ease of
■
installation and servicing.
Additional clearances might be required for wall, door, and
■
floor moldings.
Additional spacing should be considered on all sides of the
■
dryer to reduce noise transfer.
For closet installation, with a door, minimum ventilation
■
openings in the top and bottom of the door are required.
Louvered doors with equivalent ventilitation openings are
acceptable.
Companion appliance spacing should also be considered.
■
6
All manuals and user guides at all-guides.com
1
6 / "
4
(159 mm)
1
28 /
(715 mm)
1
3 / "
2
(89 mm)
14"
(358 mm)
Closet installation (dryer only):
"
8
4"
(102 mm)
Cabinet installation (dryer only):
(178 mm)
4"
(102 mm)
34" recommended
(864 mm)
18" min.
(457 mm)
(76 mm)
1"
(25 mm)
1"
(25 mm)
7"
1"
(25 mm)
3"
(76 mm)
48 in.
2
(310 cm )
2
24 in.
2
(155 cm )
2
3"
18"
(460 mm)
1"
(25 mm)