Dyna-Glo DGB515SDP Mode D'emploi page 9

ASSEMBLY INSTRUCTIONS
5. Assemble bottom shelf assembly to the left
leg assembly (O) and right leg assembly (V) with
four M6X16 bolts (DD).
Hardware Used
DD M6x16 Bolt
6. Use four M6x16 bolts (DD) to fasten the cart
rear support (R) to the left and right leg
assembly. Please note the cart rear support's
(R) direction, the side with the rivet nut in the
middle should be upward. Then use two
M5x12 bolts (EE) to fasten the cylinder block
bar (Q) between the cart front panel - lower (U)
and the cart rear support (R).
Hardware Used
DD M6x16 Bolt
M5x12 Bolt
EE
5
V
x 4
6
x 4
x 2
U
9
O
DD
Bottom Shelf
Assembly
DD
R
Q
EE
R