Dyna-Glo DGB515SDP Mode D'emploi page 20

OPERATION INSTRUCTIONS
Lighting The Grill
Before first use:
Remove all hangings or plastic straps, if present. Before you cook on your new gas grill, it is important
to clean your grill with heat. To do this, operate the grill for approximately 15 minutes with the lid closed
and the control knob in the highest position. This will clean the internal parts by burning off any residue
and odor from the manufacturing process.
If the flame extinguishes accidentally during ignition or operation, immediately TURN OFF the
cylinder valve and then TURN OFF the control knob.
Do not lean over grill when lighting. Read instructions before lighting.
1. Check that the control knobs are in the
2. Open valve at tank fully by turning
3. Open lid during lighting.
4. Depress and turn control knob counterclockwise
high position. You may need to repeat several times to ignite the burner.
If ignition does not occur in 5 seconds, turn the control(s) off,
procedure.
If the burner still does not light, check that there is gas in the cylinder and follow the match lighting
instructions. Check the Troubleshooting Guide on page 25 for more information.
CAUTION
WARNING
O
OFF position.
counterclockwise.
from off position, past the
20
O
wait 5 minutes, and repeat the lighting
ignite position, to the