Dyna-Glo DGB515SDP Mode D'emploi page 12

ASSEMBLY INSTRUCTIONS
11. Pre-assemble two M6x16 bolts (DD) onto the
grill body assembly (C) and do not tighten
them and make sure to leave a 5mm gap
between the bolt and grill body's end cap.
Then hang the right side burner body (M) on
the bolts and fasten the right side burner body
(M) with three M6x16 bolts (DD) and tighten
all bolts.
Hardware Used
DD M6x16 Bolt
12. Use two M4x10 bolts (II) to assemble the side
burner valve assembly and control knob bezel
(N) to the right side burner body (M).
Hardware Used
II M4x10 Bolt
11
x 5
12
x 2
12
DD
C
5mm
M
M
N
II