Backrest; Q.angle Adjustable Backrest - Sunrise Medical QUICKIE 2 Mode D'emploi

ENG LIS H
P. BACKREST
51
1. Height Adjustment
a. Remove nylon tie from backrest upholstery
b. You will see the Backrest Height Adjust bolt on the inside of the frame. (A) Loosen and remove from
both sides of the frame.
c. Adjust to the desired backrest height. (measured with chair unfolded, from top of seat sling to highest
point on Upholstery) and align threaded insert of back cane with the closest hole in frame.
d. Insert bolt through frame and thread into the insert in back cane.
e. Torque fasteners on both sides of chair.
f. Insert nylon tie through upholstery grommet and frame tab. Tighten and cut off excess nylon tie.
NOTE– Do not use the top angle adjustment hole for adjusting the back height.
NOTE– Use a torque setting of 144 in-lbs. when adjusting backrest.
Q. ANGLE ADJUSTABLE BACKREST (Option)
52
1. Angle Adjustment
a. Loosen button head screws (B) until the eccentric offset washer (C) moves freely.
b. Adjust backrest to desired angle, aligning eccentric offset washer in slot.
c. Tighten button head screws.
d. Repeat for opposite side.
2. Pivot Point Height Adjustment
a. Remove button head screw (D) from the frame.
b. Adjust backrest to obtain desired pivot point height.
c. Replace and tighten button head screw.
d. Repeat for opposite side.
3. Backrest Height Adjustment
a. Remove button head screw (E).
b. Adjust back tube to desired height.
c. Replace and tighten button head screw.
d. Repeat for opposite side.
NOTE– Use a torque setting of 144 in-lbs. when adjusting backrest.
4. Back Depth Adjustment
NOTE: This adjustment is intended to compensate for differences in after-market backrest thickness and/or
contour. The back-canes can be adjusted fore and aft relative to the seat so that the backrest support surface
does not change the location of the user, regardless of the backrest mounting location. This ensures that the
center of gravity of the user relative to the axle location, is not altered due to after-market backrest thickness
or contour. There is no recommendation for Depth Adjustable Backrest use for transit.
When adding an after-market back, the back canes can be moved forward or rearward by repositioning the
backrest pivot plate (F) in the pre-drilled holes on the frame.
R. BACKREST TENSION ADJUSTABLE
1. To install the Backrest Tension Adjustable
a. Slide Velcro straps (A) over the backrest frame (B)section. Make sure to include at least
one strap below the towel bar (if using a rigid chair).
b. Tighten the straps appropriately to desired tension level. DO NOT overtighten straps as
this will cause undue strain upon the chair backrest frame (B).
c. If using inegral push handles (C), slide straps from bottom of backrest upward.
d. Install backrest cover at desired level and fold over rear of Velcro strapping system (D). The
Quickie patch should be upright on the rear of the chair.
e. Finish installation by placing vanity flap (center panel) down onto Velcro on the seat sling to
secure attachment (E).
All manuals and user guides at all-guides.com
53
54
55
56 57 58
IX. DEALER SERVICE AND ADJUSTMENT
25
51
52
53
pivot
point
54
55
56
MK-100070 RevA