Kärcher 250 Manuel D'utilisation page 4

ENGLISH
• Push the switch back into
position 0 and loosen the
accumulation of dirt by
wiping with the felt strip.
(Fig. P)
• Activate the vacuum by
pushing the unit switch into
position II. Draw the rubber
blade from top to bottom
over the surface being
cleaned, while at the same
time applying a small
amount of pressure. The
dirty water is thus
vacuumed off. (Fig. Q)
• Finally vacuum off the lower
edge of the surface and then
push the switch back to
position 0. (Fig. R)
Cleaning and storing the unit
• Press the release buttons at
the side and detach the
dirty-water tank from below.
(Fig. S)
• Empty the dirty-water tank.
When replacing it
in the unit, make sure that
the release buttons snap
into place. (Fig. T)
The dirty-water tank should always be
emptied before the fresh-water tank is refilled,
otherwise water can overflow and damage the
unit.
• Always recharge the battery overnight before storing
the unit. (Fig. C)
All manuals and user guides at all-guides.com
• The grip section of the
Indicator lamp on the unit
• The indicator lamp can illuminate briefly when the
• If the indicator lamp is
Replacing the rubber blade and felt
strip
• Replace the rubber blade if there are still stripes on the
• To replace the rubber blade or felt strip, open the slider
• When replacing the rubber blade, take into account that
• Replace the cover and lock into place by closing the
4
cleaning head can be
fastened to the carrying
handle on the unit for
storage or transport
purposes. (Fig. U)
vacuum action is switched on.
continuously illuminated
while the unit is in use, the
battery must be recharged
immediately. (Fig. V)
surface being cleaned after it has been vacuumed.
on the cleaning head and remove the cover of the
cleaning head. (Fig. W)
it can be inserted from both sides and used twice. (Fig.
X)
slider
Window Washer