IFM Electronic efector200 OJ5192 Notice Pour Utilisateurs page 7

Programming the output function
Press for 10s.
* The output function can be programmed in exactly the same way using the
programming wire (pin 2). To activate the functions the programming wire is
connected for the appropriate time to L+ (pin 1).
Operation
Check the safe functioning of the unit. Indication by LEDs.
LED green is lit
LED yellow is lit
LED red is lit
LEDs
yellow + red
Maintenance
Keep the lens of the sensor free from soiling.
ENGLISH
The red LED starts to flash fast.
Then the yellow and green LEDs
flash alternately. After 10s all LEDs
go off, the output function has
changed from light-on mode to
dark-on mode (or vice versa).
Unit is ready for operation.
Output is switched.
Error in object detection, e.g. maladjustment,
soiling of the lenses.
Flash alternately, 2 Hz: output short-circuited.
Flash alternately, 1 Hz: internal malfunction
(output is not switched).
7