Operation; Before Use; Connecting; Disconnect - ULTIMATE SPEED ULGD 3.8 A1 Traduction Du Mode D'emploi D'origine

DANGER OF CHEMICAL
BURNS!
Wear protective glasses! Wear
■
protective gloves! If eyes or skin has
come into contact with battery acid,
rinse the affected body region off
GB
with a large amount of clean water
and consult a doctor straight away!
Avoid causing a short circuit when
■
connecting the charger to the bat-
tery. Connect the negative pole
connector cable only to the nega-
tive battery or to the body work.
Connect the positive pole connector
cable only to the plus pole of the
battery!
Do not place the charger close to fire,
■
heat or to places with long-term expo-
sure to temperatures over 50 °C!
Ensure that no fuel lines,electric
■
cables, hydraulic or water pipes
are damaged by the screws during
assembly of the charger!
Do not cover the charger with any
■
objects!
Protect the electrical contact sur-
■
faces of the battery from short
circuiting!
Only use the charger for charging
■
and for charge retention of 6 V / 12
V lead batteries.
Do not charge frozen batteries.
20
All manuals and user guides at all-guides.com

Operation

Before use

♦
♦
♦
♦

Connecting

NOTES
►
♦
♦
♦
♦
♦
♦

Disconnect

♦
♦
♦
Before connecting the charger, the operating
instructions must be observed.
Furthermore, the instructions of the vehicle man-
ufacturer regarding a permanently connected
vehicle battery must be observed. Secure the
vehicle, switch off the ignition.
Clean the battery poles. Take care that while doing
so, your eyes do not come into contact with the dirt.
Ensure sufficient ventilation.
There are two options for connecting the charger.
Connect the negative terminal connecting cable
(black) either directly to the negative terminal of
the battery or to the bodywork. Please also bear
in mind the vehicle manufacturer's instructions.
Before starting the charging or trickle charging
procedure on a permanently installed battery in
a vehicle, first disconnect the negative terminal
connecting cable (black) of the vehicle from the
negative terminal of the battery. The negative
terminal of the battery is usually connected to
the vehicle's coachwork.
Connect the positive pole clamp (red)
charger to the positive pole of the battery.
Connect the negative pole clamp (black)
negative pole of the battery or to the bodywork.
Connect the mains cable
the mains socket.
The battery voltage display
rent battery voltage.
Should the connection of the clamps be swapped,
the LED „reverse connection"
Disconnect the appliance from the mains supply.
Remove the negative pole clamp (black)
from the negative pole of the battery or from the
bodywork.
Remove the positive pole clamp (red)
the positive pole of the battery.
of the
to the
of the charger to
shows the cur-
lights up.
from
ULGD 3.8 A1