Safety Instructions; Unpacking - IKA R 474 Mode D'emploi

All manuals and user guides at all-guides.com
• Read the operating instructions in full
before starting up and follow the safety
instructions.
• Keep the operating instructions in a place whe-
re they can be accessed by everyone.
• Ensure that only trained staff work with the ap-
pliance.
• Follow the safety instructions, guidelines, occu-
pational health and safety and accident preven-
tion regulations.
• The stand pillar must be inserted into the base-
plate so that the guide groove is at the back.
Other alignments are not permissible, as other-
wise the stand can topple over when a unit is
mounted on it.
• Set up the stand in a spacious area on an even,
stable, clean, non-slip, dry and fireproof surface.
• Any small unevennesses that cause the stand to
rock must be compensated for with the height-
adjustable feet.
• The T 65 D ULTRA-TURRAX
must be lifted on to the guide head of the te-
lescopic stand with the aid of an assistant, and
secured with the two screws and toothed lock
washers (supplied), in accordance with the T 65
D ULTRA-TURRAX operating instructions. The
®
unit must be mounted in front, vertically abo-
ve the baseplate; a different alignment is not
permissible, as otherwise the assembly could
topple over.
• The overhead stirrer IKA
lifted on to the guide head of the telescopic
stand with the aid of an assistant, and secured
with the four screws (supplied), in accordance
with the IKA RW 47 D operating instructions.
®
The unit must be mounted in front, vertically
above the baseplate; a different alignment is
not permissible, as otherwise the assembly
could topple over.

• Unpacking

- Please unpack the device carefully
- In the case of any damage a detailed report
must be set immediately (post, rail or forwar-
der)

Safety instructions

• This telescopic stand must be fitted with a sa-
• Switch the unit off before moving the telesco-
• When lowering the telescopic stand, take care
• Only switch the unit on when the tool (agitator
• The handwheel bolt on the stand can come
• Raise or lower the stand (after slackening the
® dispersion unit
• Secure the vessel against spinning round, by
• Beachten Sie die Betriebsanleitung des Disper-
•
RW 47 D must be •
®
Unpacking
• Delivery scope
For technical reasons associated with shipping,
the telescopic stand is supplied stripped down,
as pre-assembled modules.
fety disconnection device, which stops the unit
if the stand is moved upwards when the unit
is operating.
pic stand upwards.
that no parts of the body get between the sa-
fety switches (danger of crushing).
or dispersion unit) is in the vessel.
loose due to vibration, which would lead to
the unit moving down. So, check the tightness
of the handwheel bolt regularly when using
the unit, and retighten it if necessary.
handwheel bolt) by applying the manual force
as close as possible to the stand pillar. The
further the force is applied from the pillar, the
more force you need to apply, plus there is an
increased risk of the equipment toppling over.
using a clamp, for example.
giergerätes T 65 D ULTRA-TURRAX
Rührgerätes IKA RW 47 D!
®
Check the appliance and accessories before-
hand for damage each time you use them. Do
not use damaged components.
Protect the appliance and accessories from
bumps and impacts.
Telescopic stand
- Telescopic stand corresponding to
the type ordered T 653 oder R 474
- Operating instructions
oder des
®
8