Cleaning And Maintenance; Error Code List - Waring Commercial WIH200 Serie Mode D'emploi

CLEANING AND MAINTENANCE

Always unplug unit after each use and before cleaning. Unplug
the unit when not in operation. The Waring
Cooktop should be cleaned after each use with warm, soapy water.
The exterior of the unit may be cleaned by carefully wiping with a
damp cloth.
Clean the cooking surface while the unit is warm, using warm, soapy
water. DO NOT USE COLD WATER ON WARM SURFACE.
Do not immerse completely in water to clean. The appliance is not to
be cleaned with a water jet.
NOTE: The cooking surface will be hot after use. Use caution when
handling cooking utensils and cookware. Any other servicing should
be performed by an authorized service representative.

ERROR CODE LIST

If LED display shows an error code, please reference to the solution
as following.
Error Code
"---" on display No cookware or cookware not induction
and beep
sounded
E1
E2
E3, E5, E7
E6
E9
Any other servicing should be done by an authorized service
representative.
Description of Error
compatible is on the cooktop.
Voltage is under 75V.
Voltage is over 145V.
The heater is damaged; please contact
the nearest authorized service facility for
troubleshooting, repair and adjustment.
The appliance is too hot. The cooking
temperature is over 450˚ at highest power level.
After the unit has cooled down, the unit will
automatically switch to standby mode. Press
ON/OFF button to restart the unit.
It may be caused by a concave pot. Change pot
and restart the induction cooktop. If the error
code still shows, please contact the nearest
authorized service facility for troubleshooting,
repair and adjustment.
Commercial Induction
®
6