Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 32
INSTALLATION
Installation
Material losses
!
If you use plastic pipework in the cold water inlet line,
you must observe the following condition:
f Install a metal pipe approx. 1 m in length at the ap-
f
pliance cold water connection. Then you can install
the plastic pipework.
- DHW outlet pipe:
Stainless steel pipe or copper pipe
Material losses
!
The instantaneous water heater is unsuitable for installa-
tion with plastic pipework in the DHW outlet line.
Flexible water connection lines
f Secure the back panel with an additional screw at the
f
bottom.
Undersink installation
1 Cold water Inlet
2 DHW outlet
Oversink installation
2
1 Cold water Inlet
2 DHW outlet
www.stiebel-eltron.com
10. Installation

10.1 Standard installation

- Electrical connection from below on unfinished walls
- Water connection on unfinished walls
For further installation options, see chapter "Installation / Instal-
lation / Installation alternatives":
- Power cable for finished walls
- Connecting a load shedding relay
- Water installation on finished walls
Opening the appliance
f Turn the cap anticlockwise. Remove by pulling it forward.
1
f Undo the screw.
2
f Pivot open the appliance cover.
Preparing the power cable
1
Fitting wall mounting bracket and appliance
1 Wall mounting bracket
2 Threaded stud
3 Threaded bush
f Remove the wall mounting bracket.
compact contr ol
compact contr
f
f
f
160
≥ 30
3
f
1
2
DHF-C |
23

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Dhf 15 cDhf 18 cDhf 21 cDhf 24 cDhf 12 c1Dhf 13 c3

Table des Matières