Videx 6200 Serie Mode D'emploi page 5

Masquer les pouces Voir aussi pour 6200 Serie:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

6200 Series
6200 Series
A
Fig. 1
E
D
G
F
G
D
Fig. 4
Fig. 7
1. In order to install the videophone, it is necessary to remove the cover, which contains all the electronics, from the base: firstly
disconnect the handset from the videophone (by removing its plug from the videophone) then insert a 5.5mm flat screw driv-
er into the clip
then rotate clockwise until you listen a "CLICK!".
A
Repeat the same operation with the other clip as shown in Fig. 1.
2. Pull outwards the top part of the cover as shown in Fig. 2. Don't pull the cover straight.
3. Put the base of the unit on the wall at approx 135cm from the finished floor (Fig. 3) to mark the points for the fixing holes
(Fig. 4) remembering that the wires
embed it into the wall vertically at approx. 140cm from the finished floor and the base.
4. Following Fig. 4, make the holes
hole
. If you have used the box 503, fix the base to the wall through the holes
F
5. As shown in Fig. 5A, connect the wires to the removable terminals following the provided installation diagram. Connect the ter-
minal blocks to the electronics contained in the cover as shown in Fig. 5B. Reinsert the handset and test system before closing.
Note: Contrast and hue trimmers can be adjusted only if the videophone is open. Note while testing the system, it is
advisable to hold the cover with your hand closing manually the hook switch of the handset (see Fig. 5B reference
6. Once testing is complete and all the necessary adjustments are made, disconnect the handset from the cover and close the unit
as shown in Fig. 6: first hook it on the bottom then push in the top until you hear a "CLICK!".
7. Reconnect the handset and hang it as shown in Fig. 7.
Art. 6286 - Installation instructions
Videophone wall mounting instructions
A
Fig. 2
B
C
G
B
C
A
Fig. 5
(Fig. 4) must be fed through the hole
E
, insert the wall plugs
B
H
B
(Fig. 4). If you use the flush mounting box 503,
F
and fix the base with the screws
C
using the screws
G
- 5 -
Fig. 3
2
1
Fig. 6
feeding the wires
D
.
D
66251130 - V4.8 - 15/05/22
B
into the
E
).
H

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

6286

Table des Matières