Mounting The Cutting Disc; Filling The Fuel Tank - Garland TEXEL 517 GB Manuel D'instructions

English

6.2.5. MOUNTING THE CUTTING DISC

1
3
3
7
5
6.2.6. HARNESS INSTALLATION
2
1 4
4
6.3. FUEL
IMPORTANT: The fuel used is highly
inflammable. If the fuel or the machine
catch fire, fight the flames with a dry dust
fire extinguisher.
Do not smoke while preparing or refueling.
Do not approach any flame or hot element
to the fuel.
Use unleaded fuel of 95° and synthetic
oil for 2 stroke engines.
Motor Fuel: Mixture (Gasoline 40: Oil 1)
2.5%.
Mix gasoline and oil in a bottle homologated for this
use. If you will mix more combustible just prepare
the amount you will use the short term. Do not use
fuel that has been stored over two months. The
fuel stored for long periods lose its characteristics
making it harder to start the engine and giving poorer
performance.

FILLING THE FUEL TANK

1. Choose an open are ato perform this situation
2. Stay away from the area where you have made the
preparation of the mixture.
3. Remove the combustible tank cap and fill with fuel.
4. Close tighly the fuel cap and remove all traces of
fuel that have been spilled with a rag.
WARNINGS:
- Always switch off the engine before refueling.
- Do not start the machine in a closed area. The
exhaust fumes and the vapours of the petrol all
contain carbon monoxide and other dangerous
chemical substances. In case of gas concentration
due to insufficient ventilation, eliminate from the
work area everything that impedes the correct flow
40/156