Aiwa VX-F20DV1U Mode D'emploi page 12

OPTIONAL AUDIO CONNECTIONS (CONTINUED)
Connecting to a decoder with a Dolby Digital(AC-3) or DTS processing
You can enjoy theater-quality realistic audio sound when playing back DVDs recorded in Dolby Digital Surround
or DTS Surround, by connecting to an AV receiver that is equipped with a Dolby Digital(AC-3) or DTS decoder.
Connect the DIGITAL AUDIO OUT (OPTICAL) terminal on this unit to the digital input on the AV receiver
with the optional optical cable. Refer to the owner's manual of your AV receiver as well.
Notes
When you connect this unit to other equipment, be sure to turn off the power and unplug all of the equipment from
the wall outlet before making any connections.
To AC outlet
Receiver equipped with a DTS or
Dolby Digital (AC-3) decoder
Front speaker (left)
Set the setup menu correctly after connecting.
Set the "Audio Output Setting" of the setup menu
correctly referring to the following below.
See "Customizing DVD Setup" in detail (page 53).
Audio Output Setting for Dolby Digital(AC-3)
Digital Stream: DOLBY DIGITAL
dts Output: OFF
Downmix Type: Surround Mode
Audio Output Setting for DTS
Digital Stream: Downmix PCM
dts Output: ON
Downmix Type: Surround Mode
12
ENGLISH
All manuals and user guides at all-guides.com
Center speaker
Rear speaker (left)
Remove the dust cap,
then keep it.
To DIGITAL AUDIO OUT (OPTICAL)
Optical cable (not supplied)
Sub woofer
To digital
audio input
Front speaker (right)
Rear speaker (right)
CAUTION
If the AV receiver is not equipped with a DOLBY
DIGITAL or DTS decoder, do not select "DOLBY
DIGITAL" or "DTS" in the "Audio Output Setting" when
connecting the AV receiver with an optical cable. Merely
attempting to play a DVD may cause a high level of
noise which could be harmful to your ears and damage
the speakers. In such a case, be sure to select
"Downmix PCM".