Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
English
ASSEMBLY AND OPERATION
APPLICATIONS
Rotation and striking function
Drilling anchor holes
Drilling holes in concrete
Drilling holes in tile
Rotation only function
Drilling in steel or wood
Tightening machine screws, wood screws
REMOVAL AND INSTALLATION METHOD OF BATTERY
1. Turn the body upside down and hold it firmly. Then, open the plate assembly
while pulling the slide lever. (Fig. 3) To remove the battery, pull it out while
holding the body tightly. (Fig. 4)
2. Pay attention to the inserting direction of the battery, insert the battery, and
close the plate assembly. When the plate assembly and the slide lever engage
each other perfectly, there will be the sound of a click. (Fig. 5)
Open
Plate ass'y
Pull
Slide lever
Fig. 3
CHARGING METHOD
NOTE: Before plugging into the receptacle, make sure the following points.
The power source voltage is stated on the nameplate.
The cord is not damaged.
WARNING:
1. Insert the plug of battery charger into the receptacle.
When the plug of battery charger has been inserted into the receptacle, pilot lamp will
blink in red. (At 1-second intervals)
12
Pull out
Rechargeable
battery
Do not charge at voltage higher than indicated on the nameplate.
If charged at voltage higher than indicated on the nameplate, the
charger will burn up.
Rechargeable
Body
battery
Fig. 4
Close
Insert
Plate
ass'y
Body
Slide lever
Fig. 5
Publicité
Table des Matières
