Greenlee 1818 Manuel D'instructions page 7

Instructions for Bending (cont'd)
7
Greenlee Tools, Inc.
7. Lower the ratchet handle to the horizontal position,
then rotate the bend control handle to the BEND
position.
Note: Set the pointer on zero with the conduit snug
against the shoe hook. The indicator does not compensate
for spring-back.
8. Ratchet the bend shoe to the desired angle as
shown by the degree angle pointer.
9. Rotate the ratchet handle to the UP position. This
will automatically move the bend control handle to
the RELEASE position. Then rotate the ratchet
handle down to the bending position, and apply
bend pressure until the lock pawl releases. A click
will be made, then rotate the ratchet handle to the
UP position. The shoe and segment may be rotated
to remove the bent conduit.
9
Speed Bending on 1/2", 3/4" and 1" Sizes
1
1. Rotate the ratchet handle to the UP position.
Remove the handle after loosening the set screw
in the ratchet handle. Place the handle on the post
located on the pivot shaft. Pull down the handle
until required bend is made.
2. To unload the bender, rotate the handle to the UP
position and remove the conduit.
Note: Bend release handle will be in the release position
for bending with handle in speed bend location.
7
4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070
1818 Mechanical Bender
Do not leave the ratchet handle in the
UP position when the bender is not in
use. A handle left in the UP position
could fall unexpectedly.