Bosch DHR1FZUC Manuel D'installation page 7

6. Connect the blower to the extractor hood with an
extension cable if required.
Use the added connector to hard-wire to the blower, if
required.
Use the wire diagram for connecting.
13 13 13 / / /
16 16 16
(21 mm) (21 mm) (21 mm)
NOTE: Confirm that the blower is securely attached to the
wall and all connections are secure.
NOTE: The unit can also be installed on the roof in
combination with a roof plate accessory. Ask your retailer
or contact the Bosch customer support at 1-800-944-2904.
5
" " "
9 WARNING
• The additional cover on the plug must always be
attached and closed for safety reasons.
• Not needed wires must be isolated, capped with
wire nuts and stored in a safe position.