Sirius SLTC93 Instructions Pour L'installation, L'emploi Et L'entretien page 17

WORKING
Mod. SL TC – Glass (dis. 15)
A: Light switch On/Off
B: Reduce speed / OFF motor
C: Luminous telltale
D: ON motor/incrase speed
E: 10 - minute timer
The touch control key allows the function desired by touching the relative key. If the electrical
power supply to the product SLTC is cut, 15 seconds are needed for selfdiagnostics after the
functions are restored. In the meanwhile, its operation may be incorrect.
SLTC93: The product works even if the panel is closed. We anyway suggest to open it as shown
in (pic. 9) if high speeds are set.
SLTC94: The ceramic front panel must be opened (pic. 8) only during service or filter main-
tenance.
Mod. SL (dis. 16)
A: Light switch on/off
B: Motor switch on/off (1st rate level)
C: 2nd rate level switch
D: 3rd rate level switch
E: 4th rate level switch
F: 10 - minutes timer
After 30 hours working model SL96 ), the push button control panel will signal the saturation
of the grease filter by lighting all the buttons.
For the models SLTC (Control Version). The saturation of the filter is indicated by the flashing
speed indicators.
Press the timer button to reset.
TIMING
As a result of the new EU65 "Energy label" and EU66 " Ecodesign" regulations issued by the
European Commission, which came into force as from January 1st, 2015 , our products have
been adapted to comply with these new requirements.
All of the models complying with the energy label requirements, are equipped with new electro-
nics including a timer device for suction speeds control, when the air capacity exceeds 650m³/h.
Internal motor models, with maximum air capacity higher than 650m³/h, are equipped with
a timer device that automatically switches the suction speed from 4
minutes operation.
The energy consumption of the appliance in stand – by mode is lower than 0.5W.
17
GB
GB
th rd
to 3 speed, after 6