Panasonic ER-GB80 Mode D'emploi page 12

Trimming beard
• Do not use with shaving foam applied or when the beard is wet.
A wet beard may stick to the skin or bunch up, making it difficult
to trim.
Adjusting the beard length
• Make sure that the trimmer is turned off.
1
1
Attach the comb
attachment for beard to the
main body. (See page 11.)
2
2
Set the trimming height.
3
3
Holding the trimmer with
the power switch facing
upward, trim by bringing
the blade in contact with
the skin and moving the
trimmer against the flow of
the beard.
• Hair trimmings may collect inside
the attachment when a large
volume of beard is cut, so discard
hair trimmings after each use.
12
Trimming without the comb attachment/
trimming the downy hair
1
1
Remove the comb attachment.
2
2
Holding the trimmer with the
power switch facing outwards,
trim by bringing the blade in
contact with the skin.
• The trimmer cannot trim hair to lengths
less than 0.5 mm.
Beard shaping
Use the trimmer without any comb attachments to properly shape
your beard.
• Use the precision trimmer for trimming narrow areas and for
detailed trimming. (See page 13.)
►Above and below lips
Holding the trimmer with the power switch at the
bottom, cut across a line with the blade at a 90°
angle to the skin.