Milwaukee M4910-10 Mode D'emploi page 9

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

 Avoid dangerous environment. Don't use in damp or
wet locations or expose to rain. Keep work area well
lit.
 Never direct a paint stream toward people or pets,
or any electrical device.
 Never start the machine if ice has formed in any part
of the equipment.
 WARNING: High pressure spray can be dangerous
if subject to misuse. The spray must not be directed
at persons, animals, electrical devices, or the machine
itself.
 Keep away from hot parts.
 Check bolts and nuts for looseness before each use.
A loose bolt or nut may cause serious motor problems.
 Before storing, allow the product to cool.
 Store in a cool, well-ventilated area, safely away from
spark and/or flame-producing equipment.
 When servicing use only identical replacement parts.
Use of any other parts may create a hazard or cause
product damage.
 Never use the sprayer without a spray tip installed.
 An injection injury can lead to possible amputation.
See a physician immediately.
 Never put your hand in front of the spray tip when in
use. Gloves will not always provide protection against
an injection injury.
SPECIFIC SAFETY RULES
5 — English
 Wear protective clothing to keep paint off skin and
hair, along with a mask or respirator during use. Paints,
solvents, and other materials can be harmful if inhaled or
if they come into contact with the body.
 Always unplug the paint sprayer, shut the unit off
and release pressure before servicing, cleaning
the tip or guard, changing the tip, or leaving unat-
tended.
 Plastic can cause sparks. Never hang plastic to
enclose a spray area. Do not use plastic drop cloths
when spraying flammable materials.
 Do not spray outdoors on windy days.
 Do not attempt to clean or unclog the spray tip with
your finger.
 Make sure your extension cord is in good condition.
When using an extension cord, be sure to use one heavy
enough to carry the current your product will draw. A wire
gauge size (A.W.G.) of at least 14 is recommended for an
extension cord 50 feet or less in length. A cord exceeding
100 feet is not recommended. If in doubt, use the next
heavier gauge. The smaller the gauge number, the heavier
the cord. An undersized cord will cause a drop in line
voltage resulting in loss of power and overheating.
 Save these instructions. Refer to them frequently and
use them to instruct other users. If you loan someone this
paint sprayer, loan them these instructions also.

Publicité

Table des Matières
loading

Table des Matières