Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
1. Remove the grease filters. See the "Range
Hood Care" section.
2. Remove mounting screws and lateral supports.
A
A. Lateral supports
B. Mounting screws
3. For vented installations:
Depending on your installation, remove either top
■
or rear rectangular vent knockout. If using round
vent, remove top rectangular knockout.
NOTE: Do not remove rectangular knockouts
if installation of range hood is to be non-venting
(recirculating).
Make sure damper pivot is nearest to top/back
■
edge of range hood.
Remove tape from damper flap.
■
NOTE: The exhaust adaptor/damper can be
installed up to 1" (2.5 cm) on either side of the
hood center to accommodate off-center ductwork.
All manuals and user guides at all-guides.com
Install Range Hood
A
4. Lift the range hood up under cabinet and determine
B
5. Use
6. Install the 4 - #10 x
If using rectangular vent, attach rectangular damper/vent
■
connectors to the range hood using sheet metal screws.
A
E
C
B
A. Vertical vent
B. Sheet metal screws
C. Hinge pin
D. Vent knockouts
E. Horizontal vent
If using round vent, attach vent transition piece
■
(purchased separately) to range hood top using
sheet metal screws.
NOTE: If the wall cap is directly behind the vent
connector, the dampers in the connector and
wall cap must not interfere with each other.
Remove the vent connector damper if they interfere.
final location by centering beneath cabinet. Mark on
the underside of cabinet the location of the 4 keyhole
mounting slots on the range hood. Set range hood
aside on a covered surface.
A
A. Keyhole slot
/
" (3 mm) drill bit and drill 4 pilot holes as shown.
1
8
A. Drill pilot hole
/
" mounting screws in pilot holes.
5
8
Leave about
/
" (6.4 mm) space between screw heads
1
4
and cabinet to slide range hood into place.
B
C
D
A
¹⁄₄"
(6.4 mm)
9
Publicité
Table des Matières
