Connecting The Am Antenna; Connecting The Speakers - JVC MX-K30 Manuel D'instructions

Getting Started

Connecting the AM Antenna

Rear Panel of the Unit
• Even when connecting an outside AM antenna, keep the indoor AM loop connected.
CAUTION:
• To avoid noise, keep antennas away from the System, the connecting cord and the AC power cord.

Connecting the Speakers

1. Open each of the terminals to connect the speaker wire leads.
2. Connect the speaker cords to the Speaker terminals of the Unit.
Connect the red (+) and black (–) cords of the right side speaker to the red (+) and black (–) terminals marked RIGHT on the System.
Connect the red (+) and black (–) cords of the left side speaker to the red (+) and black (–) terminals marked LEFT on the System.
3. Close each of the terminals to securely connect the cords.
Right side (rear view)
CAUTIONS:
• A TV may display irregular colors if located near the speakers. If this happens, set the speakers away
from the TV.
• Use speakers with the correct impedance only. The correct impedance is indicated on the rear panel.
5
AM loop antenna (Supplied)
AM antenna wire (not supplied)
If reception is poor, connect the outside antenna.
Left side (rear view)
Red Black
Black
Red
Turn the loop until you
have the best reception.
Attach the AM loop to its
base by snapping the
tabs on the loop into the
slot in the base.