Emptying The Fresh Water Reservoir; Transport; Storage - Kärcher BD 30/4 C Mode D'emploi

Figure 6, see cover page
1 Fresh water tank
2 Drain outlet fresh water tank
3 Fresh water tank cover
4 Fresh water reservoir filler neck
 Remove the waste water tank.
 Remove the fresh water reservoir
from the appliance.
 Check whether the drain opening
has been closed correctly.
 Open the cover of the fresh water
reservoir.
 Pour in water/detergent mixture.
Maximum temperature of the liquid
50 °C.
 Close the cover of the fresh water
reservoir.
 Insert the fresh water container into
the appliance.
 Attach and lock the waste water
tank.
Cleaning
Figure 7, see cover page
1 Vacuum bar rotary knob
2 Power switch
3 Safety button
4 "ECO mode" button
 Turn the rotary knob for lowering
the vacuum bar in an anti-clockwise
direction - the vacuum bar is low-
ered.
 Set the appliance switch to "I".
 Pull the safety switch towards the
steering device - the brush drive
and suction are switched on.
The device will move forwards.
Selecting the cleaning performance
At the start of cleaning, the device is in
ECO mode. "ECO" is shown in the dis-
play.
The "ECO mode" button switches back
and forth between ECO mode and in-
creased cleaning performance.
 Release the safety switch.
 Press the "ECO mode" button.
 Pull the safety switch towards the
steering device.
Dispensing the detergent solution
 Press the Detergent solution button
when the device is running.
The dosing is shown in the display.
Dosing is continued by one stage
each time the button is pressed.
Figure 8, see cover page
1 Detergent solution dosing OFF
2 Detergent solution dosing stage 3
Suction during reverse movement
 Press the steering device down-
wards so that the brush is raised -
the vacuum bar turns to the front
side of the device.
6
 Lower the device.
 Pull the device backwards.
Cleaning without suction
 Set the appliance switch to "0".
 Swivel the vacuum bar centrally un-
der the device.
 Raise the vacuum bar, press the
vacuum bar rotary knob in and turn
it clockwise.
 Set the appliance switch to "I".
 Press the Suction button - suction is
switched off after approx. 5 sec-
onds.
 Perform the cleaning operation.
Complete cleaning
 Release the safety switch.
 Set the appliance switch to "0".
 Raise the vacuum bar, press the
vacuum bar rotary knob in and turn
it clockwise.
 Pull the steering device unlocking
mechanism upwards and hold it.
 Put the steering column in a vertical
position.
 Release the unlocking mechanism
for the steering device.
Emptying the waste Water tank
Note:
If the waste water tank is full, the float
closes the suction channel. The suc-
tion operation is interrupted. Empty the
waste water tank.
WARNING
Please observe the local provisions re-
garding the wastewater treatment.
 Switch the device off (see section
"Completing cleaning").
Figure 9, see cover page
1 Lock
2 Cover dirt water reservoir
3 waste water tank
4 Fresh water tank
5 Closure waste water tank
 Swivel the two locks upwards.
 Remove the lid.
 Remove the waste water tank (see
section "Removing the waste water
tank").
 Pour out dirt water.
 Open the lock.
 Completely empty the tank.
 Rinse the waste water tank with
clear water.
 Close the lock.
 Carefully attach the waste water
tank onto the fresh water tank. Do
not damage the components
marked with arrows.
 Swivel the locks upwards.
 Attach and lock the cover.
4
-
EN
Emptying the Fresh Water
Reservoir
 Remove the waste water tank (see
section "Removing the waste water
tank").
Figure 6, see cover page
1 Fresh water tank
2 Drain outlet fresh water tank
3 Fresh water tank cover
4 Fresh water reservoir filler neck
 Remove the fresh water reservoir
from the appliance.
 Open the drain opening of the fresh
water tank.
 Pour out the cleaning liquid.
 Close the cover of the fresh water
reservoir.
 Insert the fresh water container into
the appliance.

Transport

CAUTION
Risk of personal injury or damage!
Mind the weight of the appliance during
transport.
 Set the appliance switch to "0".
 Pull the steering device unlocking
mechanism upwards and hold it.
 Swivel the steering device into the
vertical position.
 Release the unlocking mechanism
for the steering device.
 Push the appliance.
or
 Set the appliance switch to "0".
 Pull the steering device unlocking
mechanism upwards and hold it.
 Swivel the steering device into the
horizontal position.
 Lift appliance by the carrying han-
dle and carry it.
 When transporting in vehicles, se-
cure the appliance according to the
guidelines from slipping and tipping
over.

Storage

CAUTION
Risk of personal injury or damage!
Consider the weight of the appliance
when storing it.
This appliance must only be stored in
interior rooms.