Replacement Accessories - Black & Decker LSTE522 Mode D'emploi

Masquer les pouces

Table Des Matières

Table des Matières

Les langues disponibles

flower beds for best practices.

• Wire and picket fences cause extra string wear, even

breakage. Stone and brick walls, curbs, and wood may

wear string rapidly.

• Do not allow spool cap to drag on ground or other

surfaces.

• In long growth cut from the top down and do not

exceed 12 inches (304.8 mm) high.

• Keep trimmer tilted toward the area being cut; this is

the best cutting area.

• The trimmer cuts when passing the unit from the

right to left. This will avoid throwing debris at the

operator.

• Avoid trees and shrubs. Tree bark, wood moldings,

siding, and fence posts can easily be damaged by

the string.

CUTTING LINE / LINE FEEDING

Your trimmer uses .065 inch (1.65 mm) diameter,

ROUND nylon line. During use, the tips of the nylon lines

will become frayed and worn and the special self feeding

spool will automatically feed and trim a fresh length of line.

Cutting line will wear faster and require more feeding if the

cutting or edging is done along sidewalks or other abrasive

surfaces or heavier weeds are being cut. The advanced

automatic line feeding mechanism senses when more

cutting line is needed and feeds and trims the correct length

of line whenever it's required. DO NOT BUMP unit on

ground in attempt to feed line or for any other purposes.

CLEARING JAMS AND TANGLED LINE (FIGURES

O, P, Q)

WARNING:

Remove the battery from the trimmer

before making any assembly, adjustments or changing

accessories. Such preventive safety measures reduce the

risk of starting the appliance accidentally. From time to

time, especially when cutting thick or stalky weeds, the

line feeding hub may become clogged with sap or other

material and the line will become jammed as a result. To

clear the jam, follow the steps listed below.

• Remove the battery from the trimmer.

• Press the release tabs (23) on the line spool cap (24),

as shown in figure O and remove the cap by pulling

it straight off.

Replacement

spool

Model #

AF-100

• Pull the nylon line spool out and clear any broken

line or cutting debris from the spool area.

• Place spool and line into spool cap with line

"parked" in slots provided as shown in figure P1.

• Insert the line end through the appropriate hole in the

spool housing. Pull slack line through until it pulls

out of the holding slots as shown in figure P2.

• Press the spool down GENTLY and rotate it until

you feel it drop into place and then push to snap

into place. (When in place, the spool will turn a few

degrees left and right freely).

• Take care to keep the line from becoming trapped

under the spool.

• Align the spool cap tabs with the slots on the spool

housing.

• Snap the spool cap back on as shown in figure Q

by depressing lugs and pressing into spool housing.

NOTE: Make sure that cover is fully positioned, listen

for two audible clicks to ensure both lugs are correctly

located. Power the appliance on. In a few seconds or less

you'll hear the nylon line being cut automatically to the

proper length.

CAUTION:

cutting line protrudes beyond the trimming blade, cut it

off so that it just reaches the blade.

NOTE: Other replacement parts (guards, spool caps,

etc.) are available through BLACK+DECKER service

centers. To find your local service location call: 1-800-

544-6986 or visit www.blackanddecker.com.

WARNING:

recommended by BLACK+DECKER for use with this

appliance could be hazardous.