Cleaning And Maintenance; Safety Advice - Bartscher 135.013 Mode D'emploi

•
Pour hot water through the funnel for filling until the embedded piece of ice melts and falls out.
•
Re-insert the plug of the unit in the outlet, turn the on / off switch to the "I" position and
continue the process of crushing, filling the funnel again with ice cubes.
•
When the crushing process is finished, you can remove the container with crushed ice. In such
a case, the contact switch is automatically deactivated, and the ice crusher stops the ice
crushing process.
•
Turn the on / off switch to the "O" position and remove the cord from the outlet (pull out the
plug!), if it is not being used further.

6. Cleaning and maintenance

6.1 Safety advice

Before beginning with repair or cleaning works make sure the device has been disconnected
o
from power socket (pull the power plug!!!) and has cooled down.
Do not use any acid agents and make sure no water ingresses the device.
o
To protect yourself from electric shock, never immerse the device, its cables and the plug in
o
water or other liquids.
CAUTION!
The device is not suited for direct washing via water jets. Therefore, you must not use any
kind of pressure water jet for cleaning the device!
6.2 Cleaning
The unit should be one cleaned after every use, as well as after longer pauses between use.
o
Remove the unit from the power source (pull out the plug from the outlet!).
o
Remove the ice container and empty it.
o
Remove the funnel for filling from the unit.
o
Wash the ice container and funnel for filling using mild cleaners. Rinse thoroughly these parts
o
in clean water.
ATTENTION!
All elements which had contact with cleaners should be rinsed thoroughly with clean water,
in order to remove all traces of the cleaner.
After washing the removed parts, you should put them again in their places.
o
Do not use steel wool for cleaning. Various elements could loosen as a result.
o
Do not use combustible cleaning materials (eg. alcohol, etc.), because there exists an increased
o
risk of fire or explosion when using the unit the next time.
The surface of the unit should be cleaned with a moist cloth. A gentle cleaner can be used for
o
stronger dirt.
Do not use aggressive cleaning materials or spray cleaners.
o
Only soft cloths should be used. Never use any type of sharp cleaners which could scratch the
o
surface.
After cleaning, you should use a soft, dry cloth for drying and polishing the surface.
o
Make sure that the unit was properly cleaned, before placing it in a dry place for further use.
o
All manuals and user guides at all-guides.com
- 19 -