Makita GA4540R Manuel D'instruction page 8

Masquer les pouces Voir aussi pour GA4540R:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

► 1. Lock nut 2. Depressed center wheel 3. Inner flange
Mount the inner flange onto the spindle.
Make sure to fit the dented part of the inner flange onto
the straight part at the bottom of the spindle.
Fit the wheel/disc on the inner flange and screw the lock
nut onto the spindle.
1
2
► 1. Lock nut wrench 2. Shaft lock
To tighten the lock nut, press the shaft lock firmly so
that the spindle cannot revolve, then use the lock nut
wrench and securely tighten clockwise.
To remove the wheel, follow the installation procedure
in reverse.
Installing or removing abrasive disc
(optional accessory)
NOTE:
Use sander accessories specified in this man-
ual. These must be purchased separately.
► 1. Sanding lock nut 2. Abrasive disc 3. Rubber pad
Mount the rubber pad onto the spindle. Fit the disc on
1
the rubber pad and screw the sanding lock nut onto the
spindle. To tighten the sanding lock nut, press the shaft
2
lock firmly so that the spindle cannot revolve, then use
the lock nut wrench and securely tighten clockwise.
3
To remove the disc, follow the installation procedure in
reverse.
Installing or removing dust cover
attachment (Optional accessory)
WARNING:
Always be sure that the tool is switched off
and unplugged before installing or removing
the dust cover attachment. Failure to do so
causes damage to the tool or a personal injury.
There are four pieces of dust cover attachment and
each is used in one of different positions.
1
► 1. Marking A 2. Marking B 3. Marking C
4. Marking D
Set the dust cover attachment so that the marking (A, B,
C or D) places as shown. Snap its pins in the vents.
Dust cover attachment can be removed by hand.
NOTE:
Clean out the dust cover attachment when it is
clogged with dust or foreign matters. Continuing
operation with a clogged dust cover attachment
will damage the tool.
1
2
3
8 ENGLISH
3
2
4

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Ga4541rGa5040rGa5041rGa6040r

Table des Matières