Dolmar PM-462 Manuel D'instructions D'origine page 13

4. TECHNICAL DATA
Model
Engine type
Self-propelled
Engine displacement
Blade width
Rated speed
Fuel tank capacity
Oil tank capacity
Grass catcher capacity
Net weight
Height adjustment
Guaranteed Sound Pressure
level at operator's position
(According to EN ISO 3744,
EN ISO 4871)
Measured Sound Power level
Guaranteed Sound Power level
(According to 2000/14/EC)
Vibration
(According to EN ISO 20643)
5. ASSEMBLY
5-1 ASSEMBLE THE FOLDING HANDLE
1. Fix the lower handlebar onto the handle bracket with
bolt, washer and locking knob. (Fig. 5)
2. Lift the two locking levers to connect the upper and
lower handle. (Fig. 6)
3. Push the locking lever closed to lock the handlebars in
the operating position. (Fig. 7)
4. Adjust the tension by turning the lock nut with a
suitable spanner. (Fig. 8)
5. Position the cable over the handle shaft. Clamp it
around the middle of lower handle by the cable clamp
and make sure the cable is fixed around the outside of
the handle. (Fig. 9, Fig. 10) Otherwise the cable may
be pinched by opening/closing the rear cover.
5-2 ADJUSTMENT FOR AN
APPROPRIATE ANGLE
1) Pull the locking lever opening.
2) Rotating the upper handle centered of the angle
adjusting gear for adjusting an appropriate angle into
the scope -15º to 15º (3 position: -15º/0º/15º) as the
Fig. 11 shown.
3) Push the locking lever closed to connect the lower
handle and the upper handle.
5-3 MOUNTING AND DISMOUNTING THE
GRASS CATCHER
1. To fit: Raise the rear cover and hitch the grass catcher
on rear of mower. (Fig. 12, Fig. 13, Fig. 14)
PM-462
B&S 675EX Series, B&S 675EX Series,
ReadyStart
No
3
190 cm
460 mm
2,800/min
1.0 L
0.6 L
60 L
31.5 kg
20-75 mm,
8 adjustment
PM-462
83.5 dB (A)
(K=3 dB (A))
94.2 dB (A)
K=1.95 dB (A)
96 dB (A)
2
6.58 m/s
2
K=1.5 m/s
PM-4602 S PM-4602 S3
B&S 750EX Series,
ReadyStart
Yes
3
190 cm
460 mm
2,800/min
1.0 L
0.6 L
60 L
34 kg
20-75 mm,
8 adjustment 8 adjustment
PM-4602 S
83.5 dB (A)
(K=3 dB (A))
94.2 dB (A)
K=1.95 dB (A)
96 dB (A)
2
6.58 m/s
2
K=1.5 m/s
2. To remove: Grasp and lift rear cover, remove grass
catcher.
5-4 STARTER HANDLE
Move the starter handle from the engine to the rope guide.
(Fig. 15)
5-5 HEIGHT OF CUT
Apply outward pressure to disengage lever from rack.
Move lever forward or back to adjust height. (Fig. 16 and
see clause 7-9)
6. FUNCTION
These lawn mowers can be retrofitted from its normal
function, based on the application purpose:
From lawn mower with rear collection to:
1. Mulching mower or as
2. Side-discharge mower.
What is mulching?
When mulching, the grass is cut in one working step, then
finely chopped and returned to the grass strip as natural
fertilizer.
Hints for mulch-mowing:
- Regular cut-back by max. 2 cm from 6 cm to 4 cm
grass height.
- Use a sharp cutting knife.
- Do not mow wet grass.
- Set max. motor speed.
- Only move at working pace.
- Regularly clean mulching wedge, housing inner side
and mowing blade.
PM-5102 S3
B&S 750EX Series,
ReadyStart ReadyStart
Yes
3
161 cm
460 mm
2,800/min 2,800/min
1.0 L
0.6 L
60 L
35 kg
20-75 mm, 20-75 mm,
8 adjustment
PM-4602 S3 PM-5102 S3
83.9 dB (A)
(K=3 dB (A)) (K=3 dB (A))
94.3 dB (A)
K=1.80 dB (A) K=2.16 dB (A)
96 dB (A)
2
7.12 m/s
2
K=1.5 m/s
Yes
3
161 cm
510 mm
1.0 L
0.6 L
65 L
38 kg
85.7 dB (A)
95.9 dB (A)
98 dB (A)
2
6.53 m/s
2
K=1.5 m/s
13