PNI K80 Manuel Utilisateur page 4

EN
WARNING
We recommend that the installation and connection to be done by qualified personnel who can correctly
understand all the specific technical terms, schemes and technical verification procedures.
For locks and electromagnetic locks with retention, the power source will be set with a delay of 0 seconds,
to prevent their burning.
For locks and electromagnetic locks without restraint, the timing will be set according to the specifications of
the lock, to prevent it from burning.
The NO (Normal Open) energized output control is designed to operate the Fail Safe electromagnetic locks.
The NC (Normal Close) is designed to operate the Fail Safe electromagnetic locks.
Thepower source can also receive the opening command on the Control + and Control - connectors with an
energized pulse type command with a voltage between 6-32V DC (<1 second, respecting the polarity).
Carefully consult the technical documentation of the electromagnetic locks before connecting them to the
power source, in order to avoid incorrect connection and irreparable damage to the equipment.
4