Important Safety Instructions; Installation Instructions; Before Using Your Appliance; Installation Of Your Appliance - Avanti CBC112Q0WG Manuel D'instructions

Masquer les pouces

Table Des Matières

Table des Matières

Les langues disponibles

~WARNING~

Read all instructions before using the appliance.

DANGER or WARNING: Risk of child entrapment.

Child entrapment and suffocation are not problems of the past. Junked or

abandoned appliances are still dangerous, even if they will "just sit in the garage a few days."

Before you throw away your old appliance: Take off the doors. Leave the shelves in place so

that children may not easily climb inside.

Never allow children to operate, play with, or crawl inside the appliance.

Never clean appliance parts with flammable fluids. The fumes can create a fire hazard or

explosion.

Do not store or use gasoline or any other flammable vapors and liquids in the vicinity of this or

any other appliance. The fumes can create a fire hazard or explosion.

Before Using Your Appliance　

Remove the exterior and interior packing.　

Check to be sure you have all of the following parts:

Before connecting the appliance to the power source, let it stand upright for approximately 2 hours.

This will reduce the possibility of a malfunction in the cooling system from handling during

transportation.　

Clean the interior surface with lukewarm water using a soft cloth.

Installation of Your Appliance

This appliance is designed to be free standing only, and should not be recessed or built-in.

Place your appliance on a floor that is strong enough to support the appliance when it is fully loaded.　

Allow 5 inches of space between the back and sides of the appliance, which allows the proper

air circulation to cool the compressor and condenser.　

Locate the appliance away from direct sunlight and sources of heat (stove, heater, radiator, etc.).

Direct sunlight may affect the acrylic coating and heat sources may increase electrical consumption.

Extreme cold ambient temperatures may also cause the appliance not to perform properly.

Avoid locating the appliance in moist areas. Too much moisture in the air will cause frost to form

quickly on the evaporator requiring more frequent defrosting of the appliance.　

Plug the appliance into an exclusive properly installed grounded wall outlet. Do not under any

circumstances cut or remove the third (ground) prong from the power cord. Any questions

concerning power and or grounding should be directed toward a certified electrician or an authorized

Avanti Products service center.　

After plugging the appliance into a wall outlet, allow the unit to cool down for 2~3 hours before placing

items in the compartment.

DO NOT INSTALL THE UNIT IN A LOCATION WHERE THE AMBIENT TEMPERATURE WILL DROP

BELOW 32 ºF OR RISE ABOVE 110 ºF. AMBIENT TEMPERATURES OUTSIDE OF THIS RANGE

WILL AFFECT THE PERFORMANCE OF YOUR UNIT AND WILL NOT ALLOW IT TO MAINTAIN THE

PROPER TEMPERATURES.