Light Kit Assembly - Craftmade Fresco FRS52-LED Guide D'installation

9. Light Kit Assembly.

Remove 1 screw from motor plate on
underside of motor housing and partially
loosen the other 2 screws. Align slotted holes
in fitter plate with loosened screws in motor
plate, allowing molex connections from
motor housing to come through hole in
middle of fitter plate-- remove and discard
plastic that holds these 2 wires together . Twist
fitter plate to lock. Re-insert screw that was
just removed and securely tighten all 3
screws with Phillips screwdriver.
Connect WHITE wire from motor housing to
WHITE wire from LED light kit. Connect
BLACK (or BLUE ) wire from motor housing to
BLACK wire from LED light kit. [ NOTE : It may
be necessary to push back sleeve on wires to
be certain of wire colors.] Be sure molex
connections snap together securely.
Remove 1 screw from underside of fitter plate
and partially loosen the other 2 screws.
Carefully arrange wiring within fitter plate.
Align slotted holes in LED light kit with
loosened screws in fitter plate. Twist LED light
kit to lock. Re-insert screw that was
previously removed and tighten all 3 screws
securely.
Align grooves on shade with nodules on
inside of LED light kit. Turn shade to the
RIGHT (clockwise) until it no longer turns.
NOTE : Pull down VERY GENTLY on shade to
make sure that shade is secured completely.
fitter plate
fitter plate
molex
connections
LED light kit
page 9
motor
housing
motor plate
molex
connections
motor
housing
nodule
groove
shade