Craftmade Fresco FRS52-LED Guide D'installation page 7

6. Wiring. (cont.)
[ PLEASE NOTE : Wall and/ or handheld remote
control must be used for fan to operate. If you do
not wish to use the wall control, please proceed to
Section 7 on the following page to continue with
fan installation. ]
To install wall control , remove existing wall
switch. Wire one of the wall controls with wire
connectors provided as shown in diagram at
right.
*Wrap each wire connector separately with
electrical tape as an extra safety measure. Gently
push wires and taped wire connectors into
outlet box.
Install one 12-volt battery (included) in wall
control.
IMPORTANT : Wall control will not function
unless battery is installed.
WARNING : Battery is to be inserted with the
correct polarity.
Since this fan comes with an LED light kit, the
dimmer switch (labeled DIM and ON ) has been
pre-set to the "ON" position ( DIM ). If you do not
wish to have dimming capability, please move
the switch to the "OFF" position ( ON ).
Select a faceplate (almond or white) and press
firmly onto front of wall control. Attach wall
control to outlet box and secure with screws
from original wall switch. Attach wall plate
(included) to wall control using 2 screws
provided with the wall control.
Modifications not approved by the party responsible for compliance
could void the user's authority to operate the equipment.
*NOTE: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to
reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
* Reorient or relocate the receiving antenna.
* Increase the separation between the equipment and receiver.
* Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
Consult the dealer or an experienced radio/ TV technician for help.
outlet
box
green/
bare
ground
green/ green/
bare bare
ground ground
black (OUT to fan)
black
black
(TO POWER supply)
black
(AC IN from
breaker box)
12V battery
(wiring for wall control)
page 7
wall
control
- 1 1
green
DIM ON
radio
radio or television
dimmer
switch
face-
plate
wall plate