Lister Petter 10 & 32 Checks & Maintenance Schedule - Altrad BELLE PREMIER XT Serie Manuel De L'opérateur

DRIVE BELT
- DO NOT try to adjust with the engine / motor running.
- DO NOT run slack.
- DO NOT operate machine with guards removed.
The drive belt is under constant even tension by a spring loaded jockey, this requires no attention. The bearings are sealed for life.
GEARBOX OIL
Note: The original gearbox oil is a synthetic oil and must not be mixed with a mineral oil.
LUBRICATION AND RUNNING
See Maintenance Schedule Section and Operating Instructions.
Remember that diesel engines vibrate more, so regularly check all nuts and bolts are tight.
oil which must be changed after 100 hours.
Lister-Petter 32 & 10 Engines
Check the fuel & lubricating oil levels
Check for oil & fuel leaks
Clean, or replace, the air cleaner element under very dusty conditions
Clean or replace the air cleaner element under moderately dusty conditions
engine handbook
Clean or replace the injectors if the exhaust is dirty
Replace the air cleaner element
Examine exhaust & induction systems for leaks, damage or restrictions
Check the battery charge winding system; refer to Workshop Manual
Check the valve clearances
Decarbonise if the engine performance has deteriorated
Clean the banjo union at the cylinder head end of oil feed pipe
Mixer
Grease Yoke Pivot
Grease Tipping Gear (10 Operations of Grease Gun)
Remove Drum and Grease Shaft
Check Nuts and Bolts
Check Gearbox Oil
Check Components for Leaks
Maintenance Instructions
Checks and Maintenance
17
Daily 50 250
Hours Hours
GB
GB
500 1000
Hours Hours