Table Des Matières - Grandhall B17001050A Manuel De Montage Et D'utilisation

N.
2 G E N E R A L
TABLE OF CONTENTS
General Information / Safety..................................................2-4
Operation.....................................................................................5
Cleaning and Maintenance........................................................6
Guide to Grilling .......................................................................7
Troubleshooting...........................................................................8
Warranty......................................................................................9
Parts List / Diagram...........................................................37-38
IM PORTANT SAFEGUARDS
WHEN USING THIS GRILL OR ANY ELECTRICAL
APPLIANCES, BASIC SAFETY PRECAUTIONS
!
SHOULD ALWAYS BE FOLLOWED INCLUDING
THE FOLLOWING:
READ ALL INSTRUCTIONS
•
USE GRILL ON A LEVEL, STABLE SURFACE
•
• DO NOT TOUCH HOT SURFACES. USE HANDLES
OR KNOBS
TO PROTECT AGAINST ELECTRICAL SHOCK DO
•
NOT IMMERSE CORD, PLUGS, OR THIS GRILL IN
WATER OR ANY OTHER LIQUID
CLOSE SUPERVISION IS NECESSARY WHEN ANY
•
APPLIANCE IS USED BY OR NEAR CHILDREN
AND/OR PETS
• UNPLUG FROM OUTLET WHEN NOT IN USE AND
BEFORE CLEANING
ALLOW TO COOL BEFORE PUTTING ON OR
•
TAKING OFF PARTS
DO NOT OPERATE ANY APPLIANCE WITH A
•
DAMAGED CORD OR PLUG. DO NOT OPERATE
ANY APPLIANCE IF IT CANNOT BE OPERATED
SAFELY OR IF IT WAS BEEN DAMAGED IN ANY
MANNER. RETURN APPLIANCE TO THE NEAREST
AUTHORIZED SERVICE FACILITY FOR
EXAMINATION, REPAIR, OR ADJUSTMENT
THE USE OF ANY ACCESSORY ATTACHMENTS
•
UNAUTHORIZED BY GRAND HALL MAY CAUSE
INJURIES, PROPERTY DAMAGE, OR DEATH
DO NOT LET CORD(S) HANG OVER TABLE OR
•
COUNTER EDGES. SECURE CORD(S) AND PLACE
CORD(S) SO THAT IT CAN NOT BE TRIPPED OVER
OR EASILY PULLED
• DO NOT LET CORD(S) TOUCH HOT SURFACES
DO NOT PLACE ON OR NEAR A HOT GAS OR
•
ELECTRICAL BURNER, OR IN A HEATED OVEN
DO NOT MOVE THE APPLIANCE WHEN IT IS IN
•
USE. ALLOW THE APPLIANCE TO COOL BEFORE
MOVING OR STORING
USE FLAME RETARDANT BBQ MITTS WHEN
•
HANDLING ANY RECEPTACLE CONTAINING HOT
OIL OR LIQUIDS
TO DISCONNECT, TURN THE CONTROL KNOBS TO
•
'OFF', THEN REMOVE THE PLUG FROM THE WALL
OUTLET
DO NOT USE THE APPLIANCE FOR ANY
•
PURPOSES OTHER THAN ITS INTENDED USE.
DO NOT ALTER THIS APPLIANCE IN ANY WAY
DO NOT USE THE APPLIANCE AS A HEATER
NEVER USE CHARCOAL, LIGHTER FLUID, OR ANY
•
FUEL IN THIS APPLIANCE
I N F O R M A T I O N / S A F E T Y
•
PRE-ASSEM BLY
Read and perform the following pre-assembly instructions:
Open lid of shipping car ton and remove unit and packing materials.
•
Open the grill lid and unpack par ts inside. Remove and discard all
packing materials from unit and par ts.
Do not assemble or operate the grill if it appears damaged. If there
•
are damaged or missing par ts when you unpack the shipping box
or you have questions during the assembly process. Refer to
back for service details.
NEVER LINE THE BOTTOM OF THE GRILL
•
HOUSING WITH ALUMINIUM FOIL OR ANY
SUBSTANCE THAT WILL RESTRICT THE FLOW OF
GREASE INTO THE GREASE RECEPTACLE
GREASE RECEPTACLE MUST BE INSTALLED
•
DURING GRILL USE
DO NOT LEAVE GRILL UNATTENDED WHEN IT IS
•
IN USE
USE ONLY ON DEDICATED, PROPERLY GROUND
•
IF AN EXTENSION CORD IS USED:
•
1) THE MARKED ELECTRICAL RATING OF THE
EXTENSION CORD SHOULD BE AT LEAST AS
GREAT AS THE ELECTRICAL RATING OF THE
APPLIANCE.
2) THE EXTENSION CORD SHOULD BE ARRANGED
SO THAT IT WILL NOT DROP OVER THE COUNTER
TOP OR TABLETOP WHERE IT CAN BE PULLED
ON BY CHILDREN OR TRIPPED OVER
UNINTENTIONALLY.
3) THE APPLIANCE MUST BE PROPERLY
GROUNDED. THE EXTENSION CORD SHOULD BE
A GROUNDING-TYPE 3 WIRE CORD.
USE AN EXTENSION CORD SUITED FOR
•
OUTDOOR USE
STORE THIS UNIT INDOORS OUT OF THE REACH
•
OF CHILDREN WHEN NOT IN USE
• DO NOT CLEAN THIS PRODUCT WHEN IT IS IN
USE OR PLUGGED INTO A POWER SOURCE.
SAVE THESE INSTRUCTIONS.
THE GREASE RECEPTACLE MUST BE VISUALLY
!
INSPECTED BEFORE EACH GRILL USE.
REMOVE ANY GREASE AND WASH GREASE
RECEPTACLE WITH A MILD SOAP AND WARM
WATER SOLUTION.
N.
2