Kuppersbusch IKE3390-2 Notice D'utilisation page 11

Problem
The compressor does not
start immediately after press-
ing the Intensive cooling, or
after changing the tempera-
ture.
Water flows inside the refrig-
erator.
Water flows on the floor.
Temperature cannot be set.
DEMO appears on the dis-
play.
The temperature in the appli-
ance is too low/too high.
Possible cause
The door is not closed cor-
rectly.
The Intensive cooling func-
tion is switched on.
This is normal, no error has
occurred.
The water outlet is clog-
ged.
Food products prevent that
water flows into the water
collector.
The melting water outlet is
not connected to the evap-
orative tray above the com-
pressor.
The FastFreeze or Intensive
cooling function is switched
on.
The appliance is in demon-
stration mode.
The temperature regulator
is not set correctly.
The door is not closed cor-
rectly.
The food products' tem-
perature is too high.
Many food products are
stored at the same time.
The door has been opened
often.
Solution
Refer to "Closing the door".
Refer to "Intensive cooling
function".
The compressor starts after a
period of time.
Clean the water outlet.
Make sure that food products
do not touch the rear plate.
Attach the melting water outlet
to the evaporative tray.
Switch off FastFreeze or Inten-
sive cooling manually, or wait
until the function resets auto-
matically to set the tempera-
ture. Refer to "FastFreeze or In-
tensive cooling function".
Keep the Functions pressed for
approximately 10 seconds until
a long sound is heard and dis-
play shuts off for a short time.
Set a higher/lower temperature.
Refer to "Closing the door".
Let the food products tempera-
ture decrease to room temper-
ature before storage.
Store less food products at the
same time.
Open the door only if necessa-
ry.
11