Publicité
ELKC212ET
ELKC212ET
Insect Destroyer
Insect Destroyer
Read carefully before use
Read carefully before use
Thank you for purchasing the ELECTRIS INSECT
Thank you for purchasing the ELECTRIS INSECT
DESTROYER.
DESTROYER.
We are confident that this device will give complete
We are confident that this device will give complete
satisfaction.
satisfaction.
Warning:
Warning:
Electric protection class: Class I
Electric protection class: Class I
Degree of protection against humidity: IPX0
Degree of protection against humidity: IPX0
This equipment can be used by children aged 8 years and over and by
This equipment can be used by children aged 8 years and over and by
persons with reduced physical, sensory or mental abilities or without
persons with reduced physical, sensory or mental abilities or without
experience or knowledge, if they are properly supervised or if instructions
experience or knowledge, if they are properly supervised or if instructions
on the safe use of the equipment have been given to them and the risks
on the safe use of the equipment have been given to them and the risks
involved have been understood. Children should not play with the device.
involved have been understood. Children should not play with the device.
Cleaning and maintenance by the user must not be carried out by
Cleaning and maintenance by the user must not be carried out by
unattended children. Never immerse the device in water.
unattended children. Never immerse the device in water.
It must be kept out of
It must be kept out of
the reach of children by fixing it at
the reach of children by fixing it at
a height of at least 2 meters from the
a height of at least 2 meters from the
ground below the device.
ground below the device.
Stabilise it at a height using the chain provided.
Stabilise it at a height using the chain provided.
Always keep the device, cord and plug away from moisture.
Always keep the device, cord and plug away from moisture.
Do not hang or lift the device by the power cord.
Do not hang or lift the device by the power cord.
At the slightest incident, unplug your device.
At the slightest incident, unplug your device.
The device can only be used indoors: use in barns, stables and
The device can only be used indoors: use in barns, stables and
similar premises is not considered as indoor use. Do not use in a bathroom.
similar premises is not considered as indoor use. Do not use in a bathroom.
It must not be used in areas where flammable vapours or explosive dust are
It must not be used in areas where flammable vapours or explosive dust are
likely to be present. If the power cord is damaged, it must be replaced by
likely to be present. If the power cord is damaged, it must be replaced by
the manufacturer, its After-sales department or any other similarly qualified
the manufacturer, its After-sales department or any other similarly qualified
person in order to reduce the risk of electric shock.
person in order to reduce the risk of electric shock.
This insect destroyer effectively eliminates flying insects WITHOUT CHEMICALS.
This insect destroyer effectively eliminates flying insects WITHOUT CHEMICALS.
The light emitted by the two ultraviolet tubes attracts insects to the internal high
The light emitted by the two ultraviolet tubes attracts insects to the internal high
voltage mesh (1000 V at a few milli-Amperes) to electrocute them.
voltage mesh (1000 V at a few milli-Amperes) to electrocute them.
4
4
Operating instructions
Operating instructions
RESPECT THE HEIGHT OF
RESPECT THE HEIGHT OF
AT LEAST 2 METRES
AT LEAST 2 METRES
Maintenance:
Maintenance:
Before any intervention, disconnect the device
Before any intervention, disconnect the device
and leave it to cool for about 15 minutes.
and leave it to cool for about 15 minutes.
Keep the device in a dry, ventilated, dust-free place.
Keep the device in a dry, ventilated, dust-free place.
Clean the dead insects off the wire mesh using
Clean the dead insects off the wire mesh using
a small brush at least once a week.
a small brush at least once a week.
In the lower part of the insect destroyer, a removable
In the lower part of the insect destroyer, a removable
container collects the insects.
container collects the insects.
This container must be emptied and cleaned at least once a week.
This container must be emptied and cleaned at least once a week.
Changing the neon (tube):
Changing the neon (tube):
Check that the device is disconnected. On the back of the unit, remove the
Check that the device is disconnected. On the back of the unit, remove the
screws and open the two fasteners on each side of the top of the outer
screws and open the two fasteners on each side of the top of the outer
mesh. Unlock the neons and replace them with new ones.
mesh. Unlock the neons and replace them with new ones.
Close the mesh properly.
Close the mesh properly.
SPARE LAMP
SPARE LAMP
reference : ELKC212ET-TU
reference : ELKC212ET-TU
Getting started:
Getting started:
Unpack the product. Once the insect destroyer is installed, connect the
Unpack the product. Once the insect destroyer is installed, connect the
power cord located at the back to a 230V power outlet and press the on/off
power cord located at the back to a 230V power outlet and press the on/off
switch (I/0).
switch (I/0).
When switched on, the tubes emit a bluish ultraviolet light. Flying insects
When switched on, the tubes emit a bluish ultraviolet light. Flying insects
are attracted to this light and touch the electric mesh. The contact of the
are attracted to this light and touch the electric mesh. The contact of the
insect with the grid electrocutes it and can sometimes cause small sparks.
insect with the grid electrocutes it and can sometimes cause small sparks.
Similarly, sometimes, at the first power up, it is possible there is a risk of
Similarly, sometimes, at the first power up, it is possible there is a risk of
electric arc at the tubes which will not reproduce there after.
electric arc at the tubes which will not reproduce there after.
Risk of electrical shock
Risk of electrical shock
Specifications:
Specifications:
Power cord: 1 m
Power cord: 1 m
Fastening chain and associated clips
Fastening chain and associated clips
2 x 6 Watt fluorescent tubes
2 x 6 Watt fluorescent tubes
1 Electronic ballast for fluorescent tubes
1 Electronic ballast for fluorescent tubes
1 High voltage electronic circuit
1 High voltage electronic circuit
Dimension :
Dimension :
Ø15mm, long. 210 mm
Ø15mm, long. 210 mm
Puissance : 6 W
Puissance : 6 W
Culot : G5
Culot : G5
Éclairage UV
Éclairage UV
Par 1 pièce
Par 1 pièce
Coverage area: 20 m2
Coverage area: 20 m2
Direct power supply 230 Volts ~50/60 Hz
Direct power supply 230 Volts ~50/60 Hz
Consumption: 11 Watts
Consumption: 11 Watts
Weight: 1100 g
Weight: 1100 g
Dimensions: 27 x 25,5 x 8,5 cm
Dimensions: 27 x 25,5 x 8,5 cm
5
5
Publicité
