Solution Filter Cleaning - Nilfisk SC450 Instructions D'utilisation

ENGLISH

SOLUTION FILTER CLEANING

1. Empty the solution tank (15) as shown in the relevant paragraph.
2. Drive the machine on a level floor.
3. Check that the switches (41 and 42) are turned to "0" and disconnect the battery connector (8).
4. Unscrew the transparent cover (A, Fig. 9), remove the gasket (B), then remove the filter strainer (C). Clean and install them on
the support (D).
NOTE
Install the gasket (B) and the filter strainer (C) properly on the cover (A) and on the support (D).
22
INSTRUCTION FOR USE
D
C
B
A
SC450 - 9099589000
Figure 9
P100669
8/12