Roger Technology B70/1DC Instructions Et Avertissements Pour L'installateur page 38

90 00
Restoring standard factory values
After having displayed the number
display shows
(indicated next to the parameter numbers).
A1
WARNING!
WARNING! After the reset, check that the parameters are adjusted to the type of installation.
n0 01
Version HW
n1 23
Year of manufacture
n2 45
Week of manufacture
n3 67
n4 89
Serial number
n5 01
n6 23
FW version
The serial number is obtained by combining the values of the parameters from
example this table shows the values (next to the parameters, they are not default values) from which
you get the serial number
o0 01
o0 23
Operations performed
o1 45
The number of performed operations can be obtained by combining the values of the parameters
o1
and adding 2 zeros. For example in this table are indicated the values (next to the parameters, are not
default values) from which is obtained the the number of
h0 01
Manoeuvre hours performed
h1 23
The number of manoeuvre hours performed is obtained by combining the values of the parameters
h0 h1
from to
values) from which you get the number
d0 01
Days the control unit is on
d1 23
The number of days the control unit is on is obtained by combining the values of the parameters
d0 d1
from to
values) from which you get the number
38
90
rE S-
flashing which signals a standard factory values reset has taken place
is not restored
01 23 45 67 89 01 23
. For example this table shows the values next to the parameters (they are not default
. For example this table shows the values next to the parameters (they are not default
, press the + and - buttons simultaneously for 4 seconds, the
01 23 45 00
01 23
i.e. manoeuvre hours.
01 23
i.e. 123 days of the control unit being on.
n0
to
, that are 1234500 operations.
n6
. For
o
up to