Allmand NIGHT-LITE GR Série Manuel D'utilisation page 18

To shut down the engine:
1. Push the 'Stop' button on the Deep Sea control
module (C, Figure 15). The lights will turn off
automatically before the engine shuts down.
2. Close the engine compartment cover.
*Note: For complete information on the Deep Sea control
module, read the Deep Sea control module operator's
manual.
15
C
Automatic Engine Shutdown System
The engine has an automatic engine shutdown system to
prevent engine damage if there is a low oil condition.
If the engine has automatically shut down, locate the
source of the failure and repair before restarting the
engine.
Light Tower Operation
Adjusting the Lights
Adjusting The Light Fixtures
Note: The light fixtures must be adjusted before raising
the light tower.
1. Shut down the engine. See Operating the Engine.
2. Adjust each fixture to the desired position. To adjust
left and right, move the fixture yoke (A, Figure 16).
To adjust up and down, loosen the locking knob (B),
adjust the fixture, then tighten the locking knob.
3. When lighting operations are complete, adjust the
light fixtures to the transport position, with the fixtures
facing straight back toward the rear of the light tower
trailer. See Transporting the Light Tower Trailer.
18
B
A
16
A
B
Rotating The Light Tower
WARNING
Failure to tighten the light tower locking knob may cause
the light fixtures to swing inadvertently, especially in windy
conditions or during transport, and could result in death
or serious injury. Always tighten the tower locking knob
securely after turning the light tower.
CAUTION
Rotating the light tower will cause the light fixtures to
swing, and could result in minor to moderate injury. Be
careful to rotate the tower slowly, and be aware of the
light fixtures while rotating the tower.
1. Shut down the engine. See Operating the Engine.
2. Loosen the light tower rotation locking knob (A, Figure
17).
3. Use the handles (B, Figure 17) to rotate the light
tower in the desired direction.
4. Tighten the light tower locking knob.
5. When lighting operations are complete, rotate the light
tower to the transport position, with the fixtures facing
straight back toward the rear of the light tower trailer.
Tighten the light tower rotation locking knob.
www.allmand.com