Fueling The Unit; Operating The Engine - Allmand NIGHT-LITE GR Série Manuel D'utilisation

13
F
E
G

Fueling the Unit

WARNING
Fire Hazard
Adding fuel to the light tower trailer with the engine
running could cause a fire resulting in death or serious
injury. Always make sure that the engine is shut down
before adding fuel to the fuel tank.
The light tower trailer has a single fuel tank with a
capacity of 48 gallons (182 L).
1. Remove the fuel cap (A, Figure 14) and add fuel
to the tank. See General Fuel Information in the
Maintenance section for fuel recommendations. The
fuel gauge (B) shows the amount of fuel in the tank.
2. Install the fuel cap after adding fuel.
NOTICE
Using engine fuels other that those recommended by the
engine manufacturer could cause damage to your engine
or its emission control system resulting in voiding the
engine manufacturer's warranty. Always read and follow
the engine manufacturer's fuel recommendations.
14
A
B
Preparing to Operate the Unit
1. Make sure that the light tower trailer is level front to
back and side to side. See Leveling and Stabilizing
the Light Tower Trailer.
2. Open the engine compartment cover.
3. Remove the dipstick from the engine and examine
the engine oil level. The engine oil level should
be between the "Full" and "Add" marks on the
dipstick. Add oil if necessary. See Engine Oil in the
Maintenance section.
4. Close the engine compartment cover.
5. Examine the fuel level in the fuel tank. Add fuel if
necessary. See Fueling the Unit.

Operating the Engine

WARNING
Automatic Engine Start Hazard
Unexpected start of engine could result in death or
serious injury. Read and follow electronic controller
operator's manual before operating or servicing this
equipment.
Your machine has a Deep Sea control module. Before
operating the engine, read the Deep Sea control module
operator's manual.
To start the engine:
1. Open the engine compartment cover.
2. Turn the Deep Sea control module On / Off switch (A,
Figure 15) to the 'On' position.
3. To manually start the engine *:
• Push the 'Start' button on the Deep Sea control
module (B, Figure 15) two times (2x).
• After the intake heater has warmed the intake, the
engine will start.
4. After the engine has started, the lights will turn on
automatically. All light circuit breakers need to be in
the 'On' position.
en
17
English